The Z-V pocket lightning counter tester is carefully designed and developed by our company's technical personnel based on the needs of power users. The product has an attractive appearance and is convenient to carry and use. It replaces traditional bulky testing equipment and methods, and is well received by professionals.
Correct Usage of Z-V Pocket Lightning Counter Tester
1. Please charge the device before use. To ensure charging effectiveness and extend battery life, use the dedicated charger. It takes about 3-4 hours to fully charge an empty battery. The red light on the charger indicates charging is in progress.
2. According to the installation height of the counter, appropriately extend the telescopic discharge rod.
3. For the dedicated grounding wire, insert one end's plug into the jack at the rear of the tester, and clamp the other end's clip to the ground.
4. Press the red button to activate high voltage for about 1 second. When the indicator light turns on (with a slight flicker), you can gently tap the connection end between the counter and the lightning arrester for testing.
5. After each tap, the tip of the discharge rod should be removed from the counter. If repeated testing is needed, do not release the button. Wait 1-2 seconds until the indicator light flickers again, then tap again for testing.
6. Continuous testing may cause the tester to heat up. Please allow appropriate intervals to reduce malfunctions and extend battery life.
7. The tester output has three levels: high, medium, and low, which can be adjusted via the toggle switch on the head to suit different types or brands of counters.
8. If the indicator light does not flash after pressing the button for more than 3 seconds, the battery needs to be charged.
9. Do not disassemble the tester arbitrarily. If the battery pack capacity significantly decreases or charging efficiency is too low, it needs to be replaced. Please purchase a dedicated battery pack from our factory.
